EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: dwight_talley on December 29, 2021, 01:43:53 pm
-
I have a Fluke 7260A counter that is not showing the Gate LED. The counter was connected to a Knight Freq Generator that was feeding 50 volts AC to the counter ground. So the counter stopped counting. I am trying to see if I can get the counter working again. Everything seems to be working just not counting. I have seen two different diagrams of the circuit board but nothing matches what I have.
My question is where would you start first? Is there a reference where I can match what I have in my board layout?
Thanks
Dwight