Products > Test Equipment

Replacement Knobs, Feet and Fittings for Test Equipment

<< < (51/52) > >>

calin:
Here is my small button for Lecroy WavePro 7300A . SCAD model and STL attached.
Note: Updated the archive as somehow was corrupted

dl6lr:

--- Quote from: BmaxTom on March 13, 2022, 04:02:52 pm ---Siglent housing spacer for e.g. SDM3065X and SDG2042X.

Printed it with a layer height of 0.2mm and infill gyroid pattern with a density of 25%.

--- End quote ---

May I ask what design you have used to print the BNC caps? I assume you have printed them, being the same color as the spacer...

BmaxTom:
BNC Dust Cap.

Printed it with a layer height=0.16mm, shells=3 and infill density=25%.

BmaxTom:
Ethernet Dust Cap.

Printed it with a layer height=0.1mm, shells=2 and infill density=25%.

dl6lr:

--- Quote from: BmaxTom on September 02, 2022, 07:37:18 am ---BNC Dust Cap.

Printed it with a layer height=0.16mm, shells=3 and infill density=25%.

--- End quote ---

Thank you. Just tested, they had too tight fit with my prints. I measured the STL indicates 9.8mm inner diameter, but my prints came with 9.55mm inner diameter, outer diameter was fine. Had to scale up a little.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod