Products > Test Equipment
Replacing OLED screen on an Agilent U1253A Multimeter
johns:
We have built a PCB using using your design based on satanistik design but still have the same problem with mirrored image
We must be doing something wrong but what we have no idea.
Do you have any suggestion what to check?
coromonadalix:
see reply #196
ultrasmurf:
How is the connection between the main pcb, small pcb (the one that suppose to invert the command), and the oled controller ?
tautech:
--- Quote from: pwrtrnx on October 21, 2020, 09:58:46 pm ---Hello Johns,
Do you still have any replacement screens left? pwrtrnx - NZ
regards
--- End quote ---
Welcome to the forum.
:-//
Kiwi with an Aussie flag ? :scared:
FYI you can remedy this in your profile settings.
Boosted_Eric:
--- Quote from: johns on October 02, 2020, 12:30:47 am ---We have built a PCB using using your design based on satanistik design but still have the same problem with mirrored image
We must be doing something wrong but what we have no idea.
Do you have any suggestion what to check?
--- End quote ---
I'm working on the same project for my power fc. Did you end up finding any type of solution? My screen is still mirrored as well.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version