Products > Test Equipment
Replacing OLED screen on an Agilent U1253A Multimeter
eb4eqa:
Hi gmarsh. Very interesting, thank you! I have one U1273A and MSO. I will look at it over the weekend ok?
Roberto
johns:
We had to redesign the conversion PCB and use different parts as well and now it is working fine.
johns:
--- Quote from: ultrasmurf on October 08, 2020, 06:07:35 am ---How is the connection between the main pcb, small pcb (the one that suppose to invert the command), and the oled controller ?
--- End quote ---
We had to redesign the PCB/schematic and use different parts, it is working now fine.
johns:
--- Quote from: Boosted_Eric on November 19, 2020, 03:42:16 am ---
--- Quote from: johns on October 02, 2020, 12:30:47 am ---We have built a PCB using using your design based on satanistik design but still have the same problem with mirrored image
We must be doing something wrong but what we have no idea.
Do you have any suggestion what to check?
--- End quote ---
I'm working on the same project for my power fc. Did you end up finding any type of solution? My screen is still mirrored as well.
--- End quote ---
Yes, we did it. See our latest post.
johns:
--- Quote from: wraper on August 02, 2020, 10:23:46 am ---
--- Quote from: Tarloth on July 30, 2020, 08:09:01 pm ---Thanks Johns, I'm interested because, off course, I have a U1253 multimeter with dim to death screen, but looking at pictures the conector it's different that multimeter connector. Are you sure that this boards work?
--- End quote ---
IMHO it's a spam from some Chinese folks. And this display has nothing to do with U1253A, connector looks similar to generic OLED display boards.
--- End quote ---
No, it is not a spam from China, I am in Perth, WA and we find the solution to fix the Ap5exi commander OLED screen replacement to work.
And further more we have some extra boards with parts as per ultrasmurf design for Agilent U1253A DMM
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version