EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: mwbarth36 on January 14, 2020, 09:51:45 pm

Title: Resetting Error Log on TDS620A Oscilloscope.
Post by: mwbarth36 on January 14, 2020, 09:51:45 pm

Does anyone know how, or if, the Error Log can be reset after a repair has been made to the TDS620A?  I have repaired an acquisition board and it now works fine, would like to get rid of the past Errors in the Log.  Have the Service Manual, but that is no help!

Title: Re: Resetting Error Log on TDS620A Oscilloscope.
Post by: Galen on January 16, 2020, 01:55:25 am

you can try, use GPIB to send command 'err clear'.  It works on TDS C and D serials.

Title: Re: Resetting Error Log on TDS620A Oscilloscope.
Post by: keystone on January 16, 2020, 08:17:11 am

I just tried that on my 620A and it didn't work. I got a time out error.