Products > Test Equipment
Retrieve config Via USB for Rigol devices
(1/1)
Ross:
Hi,

I know that the configuration of a Rigol PSU or Sig gen can be saved to a USB disk or to the instruments internal memory. Is there a way of retrieving it via the USB slave port (i.e on a PC)?

Thanks,

Ross
thm_w:
Depends on the device. You'll have to read the associated SCPI programming guide to find out.

In some cases there are SCPI commands to read back the entire configuration, in other cases there might not be, and you'd have to read back each setting one at a time.

https://www.batronix.com/pdf/Rigol/DP800_ProgrammingGuide_EN.pdf
Ross:

--- Quote from: thm_w on August 23, 2022, 11:20:18 pm ---Depends on the device. You'll have to read the associated SCPI programming guide to find out.

In some cases there are SCPI commands to read back the entire configuration, in other cases there might not be, and you'd have to read back each setting one at a time.

https://www.batronix.com/pdf/Rigol/DP800_ProgrammingGuide_EN.pdf

--- End quote ---

Thanks for your quick reply, I have a DP800 series PSU and have looked through the programming manual before and have not found a command for full configuration output. Can you point me to the SCPI command?
thm_w:

--- Quote from: Ross on August 24, 2022, 01:42:28 am ---Thanks for your quick reply, I have a DP800 series PSU and have looked through the programming manual before and have not found a command for full configuration output. Can you point me to the SCPI command?

--- End quote ---

If you didn't see it, it doesn't exist on the DP800.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod