EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: hafrse on January 26, 2022, 06:21:36 pm

Title: Retrofitting tracking generator in Rohde & Schwarz FSEM Spectrum analyzer
Post by: hafrse on January 26, 2022, 06:21:36 pm

Hello,

I hvae access to a tracking generator kit for the Rohde & Schwarz FSE spectrum analyzers (cables, board and attenuator) ,  if it possible to retrofit that without an option code?

Thnaks 

Title: Re: Retrofitting tracking generator in Rohde & Schwarz FSEM Spectrum analyzer
Post by: xmo on January 26, 2022, 07:31:51 pm

It will probably work fine.  I put one in an FSP with no problems.  The nice thing is that the TG cal data is on the card.

Title: Re: Retrofitting tracking generator in Rohde & Schwarz FSEM Spectrum analyzer
Post by: hafrse on January 26, 2022, 07:34:46 pm

Quote from: xmo on January 26, 2022, 07:31:51 pm

It will probably work fine.  I put one in an FSP with no problems.  The nice thing is that the TG cal data is on the card.

Correct, I checked, it is a hardware option B10 (TG 7GHz)  and should work without any software key.  I think most of the HW options are plug and ply, cal values in the module ifself.