| Products > Test Equipment |
| Reverse engineering Tektronix TDS3GV module for TDS3000 series oscilloscopes? |
| << < (19/21) > >> |
| mankan:
Can anyone explain why I need to pull up resistors on the TX/RX pins? Without them the Wemos D1 mini won't start running the sketch when connected to the scope. One clue could be that my LED is lit, pin D0/GPIO16/~WAKE. I did not read up on reserved ESP8266 GPIO pins when I made the board. Attaching my schematics and the Wemos one I think I have. |
| sicco:
My most recent 'budget version' plugin boards arrived this week. More on https://www.eevblog.com/forum/testgear/tds3000c-series-bw-sampling-hack/ |
| Gyagel:
Is there anybody with recent revision PCB from Russia here? I would like to buy 1 piece. Please, PM me! |
| AnJu:
--- Quote from: Gyagel on February 22, 2021, 10:44:26 pm ---Is there anybody with recent revision PCB from Russia here? I would like to buy 1 piece. Please, PM me! --- End quote --- Yes. PM sent! |
| JacquesBBB:
Hi All, I have a TDS2CM communication board. Do you think there a way to make a cable from the 100-pin connector of the TDS3032 to the 50 pin connector of the TDS2CM that will make it work and provide RS232, GPIB and centronics ports to the TDS3032 ? |
| Navigation |
| Message Index |
| Next page |
| Previous page |