Products > Test Equipment
Riden 6018 damaged during LED ON/OFF mod
(1/1)
NickyDoes:
I was attempting to add the output on/off red LED mod to a RIDEN RD6018. In the process, I blew a pin on the STM32 microcontroller that drives the green on/off LED. I have a replacement STM32 and can replace the component, but I do not know how to initially program a STM32. I have a ST Link V2 and I see what looks to be a programming header @ J2. Please point me in the right direction.
darkspr1te:
You will need a copy of bootloader and firmware, the firmware that comes from Riden is encrypted and is decrypted by the bootloader,


i dumped my bootloader+firmware from a 6012 found here

https://www.eevblog.com/forum/microcontrollers/rd60xx-mcu-controlled-power-units/msg4543973/#msg4543973

you might be able to flash that and get to the bootloader, but no promises

darkspr1te
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod