Products > Test Equipment

Rigol 1054z and 1074z timing problems at 500ms timescale and 24M memory depth

<< < (4/6) > >>

Howardlong:

--- Quote from: Sredni on August 26, 2020, 09:00:48 pm ---LOL, the OP on EESE (OMG! WTF am I doing with all this acronyms?) has received a reply from Rigol, saying to upgrade to the version of firmware he already has, and that is affected by the bug.
(This information is in the comments, and the question has been closed as off-topic - in fact it's not a question about how to find the resistance for a LED... >:D )

Perhaps somebody should write a bug report in Chinese?

--- End quote ---

The value of the websites like that is so degraded by activity such as marking things as "off topic" to close them.

The other useless trick they use, presumably to fraudulently improve their click rate, is to mark completely unsolved questions as solved. Toms Hardware is probably the worst for falsely claiming unsolved questions as solved.

Of course, there's no reasonable way open to contest these arbitrary and disingenuous decisions.

Elmue:
Hello

I'am the "OP" how published the bug at StackExchange.

My thread has been reopened. So I could post an answer now:

https://electronics.stackexchange.com/a/518731/101597

BlackDogWhite:
Just accept that I'm an idiot. 

How do I select some different Sa rate?  The menu item always seems disabled.

Kean:

--- Quote from: BlackDogWhite on August 27, 2020, 11:06:34 pm ---Just accept that I'm an idiot. 

How do I select some different Sa rate?  The menu item always seems disabled.

--- End quote ---

You need to change the memory depth which then changes sample rate based on timebase.  Or at least that is what I did.
You also must be in run mode to change it, and only have channel 1 enable.

I tested it on my MSO1104Z and got the same results.  I added a reply with my findings on Stack Exchange.

Adrian_Arg.:
We have to flood Rigol with emails with complaints, to see if we can get them to fix the failure.

in spanish
nosotros tenemos que inundar de mails con reclamos a Rigol, para ver si  conseguimos que arreglen el fallo.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod