Products > Test Equipment
Rigol 1054z and 1074z timing problems at 500ms timescale and 24M memory depth
<< < (5/6) > >>
Fungus:

--- Quote from: BlackDogWhite on August 27, 2020, 11:06:34 pm ---Just accept that I'm an idiot. 

How do I select some different Sa rate?  The menu item always seems disabled.

--- End quote ---

You can only change it when the 'scope is running, not when it's paused.
Adrian_Arg.:
It would be good to know how many users of the rigol ds1000z have made the claim to rigol ::)


Seria bueno saber cuantos usuarios del rigol ds1000z han hecho el reclamo a rigol ::)
Joe M:
I wonder if this sort of thing happens with the other Chinese brands like GW Instek, Siglent, Owon or Hantek.

Shame on you Rigol :-- If many of you complain there's a chance that Rigol will listen and correct the issue. Dave should make a video of this, I bet Rigol will come running after that.

I own a Rigol Spectrum Analyzer and an arbitrary waveform generator, haven't had any problems yet, that I know of..  :phew:
Adrian_Arg.:
After several months, the people of rigol consulted me what version of firmware I had installed and a screenshot, since the last firmware revision corrected that error, because it did not correct it, it remains the same !!!! |O |O |O
Sredni:
I mean, don't they have at least one scope to test it themselves???
All they had to do is plug the probe on the calibration output and turn two knobs.

Shameful.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod