Products > Test Equipment

Rigol 1054z and 1074z timing problems at 500ms timescale and 24M memory depth

<< < (5/6) > >>

Fungus:

--- Quote from: BlackDogWhite on August 27, 2020, 11:06:34 pm ---Just accept that I'm an idiot. 

How do I select some different Sa rate?  The menu item always seems disabled.

--- End quote ---

You can only change it when the 'scope is running, not when it's paused.

Adrian_Arg.:
It would be good to know how many users of the rigol ds1000z have made the claim to rigol ::)


Seria bueno saber cuantos usuarios del rigol ds1000z han hecho el reclamo a rigol ::)

Joe M:
I wonder if this sort of thing happens with the other Chinese brands like GW Instek, Siglent, Owon or Hantek.

Shame on you Rigol :-- If many of you complain there's a chance that Rigol will listen and correct the issue. Dave should make a video of this, I bet Rigol will come running after that.

I own a Rigol Spectrum Analyzer and an arbitrary waveform generator, haven't had any problems yet, that I know of..  :phew:

Adrian_Arg.:
After several months, the people of rigol consulted me what version of firmware I had installed and a screenshot, since the last firmware revision corrected that error, because it did not correct it, it remains the same !!!! |O |O |O

Sredni:
I mean, don't they have at least one scope to test it themselves???
All they had to do is plug the probe on the calibration output and turn two knobs.

Shameful.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod