Products > Test Equipment
Rigol DG1022Z unlock
scottie4442:
I tried to unlock my new DG1022Z. I have read all the posts on this, including the DP832 post that includes the DG1000Z info. I am using Linux and the telnet works fine, *IDN? shows me the correct info, but when I type :PROJ:SET MODEL,DG1062Z with plugged in usb with keyfile.bin it gives me an error. The firmware on my DG1022Z is 03.01.12, not sure if this makes a difference. Thanks for any help.
jcfoto:
Hello Scottie
Last mounth, i'd applyed operating mode of
https://www.eevblog.com/forum/testgear/need-help-hacking-dp832-for-multicolour-option/325/
This, on my recent DG1022Z -> 1062Z and DP832 -> 832A.
My system is Ubuntu 20.04 and i'd send SCPI commands via USB port.
For DP832, command line is :PROJ:SET MODEL,DP832A but for DG, it's not the same :
:PROJ:STAT MODEL,DG1062Z ( STAT, not SET !).
Regards
sequoia:
In addition of changing model from DG1022z to DG1062z, 16M memory option can be enabled as well.
Looks like riglol has not yet been updated to support generating the license codes for DG1000z series. But there is updated version found here: https://www.eevblog.com/forum/testgear/need-help-hacking-dp832-for-multicolour-option/msg2538783/#msg2538783
Attached is patch against riglol-1.1.2 based on changes found in the original post (above). You can download riglol-1.2.2 sources and apply this patch, then compile...
(worked fine for me on my DG1022z...)
riglol-1.1.2-dg1000z-patch.txt (4.62 kB - downloaded 409 times.)
Mecanix:
For the ver upgrade you really need the USB thumb drive to be re-partitioned with a <4GB FAT partition (not NTFS, not FAT32), or you'll get the error you are getting otherwise.
Also no need to restore previous firmware, it works perfectly fine on the 03.01.12 too and so is the Arb16mb Option. I've upgraded mine (also 03.01.12) without a glitch; other than having to re-partition a USB drive to FAT, all worked great.
scottie4442:
ok I installed Ultra Signma, and the german program. Tried to run the command and these are the results in Ultra Sigma
* Connected to: TCPIP::10.10.30.31::INSTR
-> *IDN?
<- (Return Count:53)
Rigol Technologies,DG1022Z,DG1*********,03.01.12
-> :PROJ:STAT MODEL,DG1062Z
<- (Return Count:0)
* Error!!!
VISA: (Hex 0xBFFF0015) Timeout expired before operation completed.
-> :PROJ:STAT MODEL,DG1062Z
<- (Return Count:0)
* Error!!!
VISA: (Hex 0xBFFF0015) Timeout expired before operation completed.
-> *IDN?
<- (Return Count:53)
Rigol Technologies,DG1022Z,DG1*********,03.01.12
I obscured my serial of course. not sure what the problem is. I created a 2GB USB FAT formatted with keyfile.bin.
not sure what to do from here.
Navigation
[0] Message Index
[#] Next page
Go to full version