Products > Test Equipment

Rigol DHO804 Test and Compare Thread

<< < (214/229) > >>

Martin72:
If you take this a bit more seriously, I would want to capture the hotspots with a thermal camera - before replacing the fan.
Most people want to install a fan externally, so it would be a good idea to monitor the temperatures with the camera.
Unless there are enough internal sensors available that can be displayed.
Is this the case and how do you do it?

ebastler:

--- Quote from: Martin72 on December 17, 2023, 09:24:25 pm ---Unless there are enough internal sensors available that can be displayed.
Is this the case and how do you do it?

--- End quote ---

You mean the Utility > Self Check > Board Test display? (If the manual is correct and it's in the same place as with the DHO1000.)

Martin72:
Aha, will check this...Now.

Martin72:
That's a bit meagre, actually too little.

Martin72:
That was a good one. ;) edit post was removed from user
Here is an example of how to do it right, if you are already doing it.


Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod