Products > Test Equipment

Rigol DP832 - Firmware list and bugs

<< < (58/153) > >>

wertyq:
I believe there is something missing from your post.

McBryce:
So I went to the bother of ordering a 3.8mm drill bit as suggested by Rigol (as far as I know) to repair the positive posts that don't take a standard 4mm banana plug. The bit slides effortlessly into the Earth and GND posts with some play, but it also slides (if somewhat slightly tighter) into the positive posts. So is 3.8mm the wrong size? How big should these holes really be? The positive post holes are definitely 3.8mm, but a banana plug doesn't fit into them. Should they be actually 3.9mm?

McBryce.

thm_w:

--- Quote from: McBryce on April 15, 2015, 07:07:27 pm ---So I went to the bother of ordering a 3.8mm drill bit as suggested by Rigol (as far as I know) to repair the positive posts that don't take a standard 4mm banana plug. The bit slides effortlessly into the Earth and GND posts with some play, but it also slides (if somewhat slightly tighter) into the positive posts. So is 3.8mm the wrong size? How big should these holes really be? The positive post holes are definitely 3.8mm, but a banana plug doesn't fit into them. Should they be actually 3.9mm?

McBryce.

--- End quote ---
0.166 inch or 4.22mm
according to these manufacturers:
https://cinchconnectivity.com/OA_MEDIA/drawings/dr-1080902001.pdf
http://muellerelectric.com/wp-content/uploads/BU-P2854-2.pdf

LaurentR:

--- Quote from: kjdotts on April 15, 2015, 10:06:48 am ---I've discovered ...
-Kris

--- End quote ---

Did you report these to Rigol?

kjdotts:

--- Quote from: LaurentR on April 16, 2015, 12:52:05 am ---
--- Quote from: kjdotts on April 15, 2015, 10:06:48 am ---I've discovered ...
-Kris

--- End quote ---

Did you report these to Rigol?

--- End quote ---

I plan to in the near future. I was going to give it a few days to see what type of response/insight/confirmation I might receive from my postings.

-Kris

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod