Products > Test Equipment
Rigol DP832 - Firmware list and bugs
kazam:
10mV sweep included for completeness. There's some positive bias. Overall well within spec.
I'll stop spamming the thread with plots now... :blah: :)
/K
bson:
--- Quote from: kazam on February 28, 2016, 07:56:28 pm ---10mV sweep included for completeness. There's some positive bias. Overall well within spec.
I'll stop spamming the thread with plots now... :blah: :)
--- End quote ---
Thanks for sharing - very informative!
kazam:
No problem!
One other finding worth mentioning is that the internal voltage measurement takes a long time to become available. On the order of 1 second. That's why I didn't bother waiting for that in the 10mV sweeps. Takes ages.
A firmware enhancement would be to sample the voltage when you request it remotely and not simply read out the currently displayed value which I think is what they're doing now. That would speed up things considerably.
--- Quote from: bson on February 28, 2016, 09:48:39 pm ---Thanks for sharing - very informative!
--- End quote ---
Skimask:
--- Quote from: McBryce on February 04, 2016, 02:49:30 pm ---If you got the "Installation Fails" message then you've probably put the wrong key in more than 3 times. As far as I can remember, the DP832 will block all license keys now for the next 24 hours, so you'll have to leave it running for a day before you can try the correct key.
McBryce.
--- End quote ---
Leave it running as in leave power on for a good 24hrs or so?
I got 3 out of 5 keys put in before I got the "Installation Fails" message. Thought I was doing something wrong. That's what I get for being in a hurry. Maybe not so much.
P.S. Using the riglol generator on a DP832 w/ 1.08, but using the 1.09 key gen on the site.
McBryce:
Yes, if you put a wrong key in 3 times then you need to leave it running for 24 hours. It doesn't have an RTC, so the timer is only ticking when it's powered up.
McBryce.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version