Products > Test Equipment

Rigol DP832 - Firmware list and bugs

<< < (114/153) > >>

TurboTom:
There are also several fuses soldered on the power boards close to the terminals where the transformer is connected. Did your LED survive the incident (i.e. no momentary overvoltage/current was present at the PSU's output terminals)? In this case, I'ld assume it's not the pass transistor that failed. Maybe a logic/control circuitry supply problem on the related power board?

frozenfrogz:
Short update of the story so far:

All the fuses on both boards check out fine, so do the current sense resistors and diodes on the outputs.
Output 1 can be switched, the relais works and the on/off LED signals an active channel. Display reads 0.000 for all values, which is correct. Everything seems fine apart from the missing voltage on CH1.
Will have to dig a little deeper...

mcinque:
Keep us informed...

smgvbest:
Does anyone have 01.16.00.02,   i download from rigol and its got 1.14 in the file though the title does say its 1.16

JDubU:
smgvbest,

Try this one:
https://www93.zippyshare.com/v/97R7Ltey/file.html

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod