Products > Test Equipment
Rigol DP832 - Firmware list and bugs
garrettm:
I just heard back from Rigol and they are going to add the 1.09 bootloader to the zip file containing the new firmware. So hopefully no one else has scrounge around when updating an older unit. They are also looking into the manual calibration issue. And finally, I also asked for the factory SCPI procedure. It'd be nice to compare the cal routines to see if there are any differences. So keep your fingers crossed.
UPDATE: Well, looks like they can't publicly release the SCPI cal routine. Oh well. On the bright side of things, they were willing to calibrate my unit for free if I ship it to them. I'm still going to give the SCPI procedure on the forum a try first; and if that doesn't pan out, I guess I'll take up their offer and mail it to Rigol. I have to admit, Rigol does have good customer service here in the US.
JDubU:
If it is of help to anyone, here is the 1.09 bootloader update file.
Be careful to read the included instructions since they say that improper installation can possibly do irreversible bad things.
cpposteve:
hi all. what is the password for the manual calibration? cheers
JDubU:
I think the calibration password is: 2012
thm_w:
--- Quote from: cpposteve on March 05, 2020, 08:52:00 pm ---hi all. what is the password for the manual calibration? cheers
--- End quote ---
Be careful with the manual cal, its possible to screw it up to the point that the psu is unusable. I would leave it as is until you can run one of the SCPI cal routines (which will require a decent DMM).
If you are cal'ing with the 121GW, there is no reason to do that IMO.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version