Products > Test Equipment

Rigol DP832 - Firmware list and bugs

<< < (143/153) > >>

Trident900fi:
Hello,

Someone try to calibrate a DP832A using a Keithley DMM6500 ?

I always get error this error "Error -113 Undefine SCPI header"
The error is reported by the DMM...

Any suggestion ?

Many thanks

skander36:
If you connect with Putty and send commands like : *opc? or CONF:VOLT:DC AUTO what you get ?

Trident900fi:
Just test with *IDN? and I get "KEITHLEY INSTRUMENT,MODEL DMM6500,04445903,1.7.0e" and the DMM freeze.

With *OPC? I get "1"

With CONF:VOLT:DC AUTO I get "Error -113 Undefined SCPI header" on the DMM and nothing in Putty.


skander36:
*opc? = 1 is ok .
But not ok to freeze .
What port are you using ?
LE - Using a SCPI console on USB you get same result ?

Trident900fi:
I use the port use by the DMM. It's the 5025. Actually I run with ethernet port.
I don't know how to manually send SCPI commands in USB ! Sorry, I begin to this area...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod