| Products > Test Equipment |
| Rigol DP832 - Firmware list and bugs |
| << < (146/153) > >> |
| alank2:
Basically I'm asking, have others had a good experience with 01.16 or are there any issues with it. :) |
| tv84:
--- Quote from: alank2 on June 24, 2020, 09:30:39 pm ---Basically I'm asking, have others had a good experience with 01.16 or are there any issues with it. :) --- End quote --- Has less issues than 01.14. |
| alank2:
The firmware upgrade instructions are quite dodgy at best. I even found this which isn't much better. https://www.bitsammler.de/downloads/Manuals/RIGOL/DP832/How%20to%20update%20DP800.pdf #1 - Start the unit with the USB stick plugged in or not? or turn it on, press help, THEN plug it in? #2 - After main update, what does "move USB flash" mean? Remove it? Does the help help m4 m2 m1 update without need of the USB stick? #3 - What is the warning in the official Rigol instructions about bricking it if you install twice all about? I don't want that. Is it so hard to have simple clear concise instructions! |
| alank2:
I got it. It was picky about the USB stick though. #1 - find a USB stick it likes, plug them in until it recognizes one. #2 - unplug it and copy GEL file to it. #3 - turn dp832 off, turn it on, when seeing the rigol graphic press and hold HELP. #4 - it will prompt to plug in stick, plug it in. #5 - it will do the update. At the end it says to power cycle, but if you wait, it will reboot itself. #6 - I had to set mine back to English language. #6 - now you can press help help and do the power boards. first m4, m2, m1 and then m4, m2, m2. #7 - reboot the whole thing. |
| Gandalf_Sr:
If a DP832 has been told it's a DP832A using the magic USB stick, will applying an official GEL file update result in the PSU staying as a DP832A? |
| Navigation |
| Message Index |
| Next page |
| Previous page |