Products > Test Equipment
Rigol DP832 - Firmware list and bugs
<< < (150/153) > >>
JDubU:
Here is firmware version 1.14 that includes the 1.09 bootloader.
Ordinaryman1971:
Thank you very much. That was a problem. Old firmware and bootloader. It was tricky though. After updating to ver. 00.01.14 I've started getting overtemperature errors, couldn't enable either channel.
I've also got an error on analog board, failure to pass selftest.... But I've loaded ver. 00.01.16 and all went back to normal.
The "upgrade" went through without problems afterwards.
So, the 00.01.16 is the newest firmware published?
But I think I have another problem on hand... look at the bottom unit and the current leakage.
And the power switch so dirty.. I swear I've got it like this.
JDubU:
Latest firmware version is:  00.01.16.00.02
JDubU:

--- Quote from: Ordinaryman1971 on November 04, 2020, 05:07:30 am ---...
But I think I have another problem on hand... look at the bottom unit and the current leakage.
...

--- End quote ---

Could be a false readout due to calibration being off.
Take a look at this thread:
https://www.eevblog.com/forum/testgear/dp832-calibration-using-python-pycharm-running-on-windows/
uremmel:
Hi,
I want to calibrate my DP832 through the manual process with a Brymen BM789. I know it's not perfect for this, but for me it's enough.  ;)
Is there anything I have to consider before doing this?
Do I have to send a clear calibration scpi command before trying?
Firmware version 1.16 is installed.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod