| Products > Test Equipment |
| Rigol DS1000Z series buglist continued (latest: 00.04.04.04.03, 2019-05-30) |
| << < (5/74) > >> |
| frozenfrogz:
--- Quote from: metrologist on April 12, 2017, 07:20:52 pm ---I was wondering if you would use an ordered list for the bug list? It's just marginally easier to parse, but a heck of a lot harder to maintain and edit. --- End quote --- Tried to do some proper formatting, could not find a BBcode option to do an indent / tab stop that seems to work here, so for the moment it’s lists within lists :-/O @Fennec: Please provide your long system info, thanks :) Also, it seems that some of the wish list items have been implemented in the recent software release. However, I do not really know how to synchronize with the wish list. I could dedicate my second post (with the quoted original post from the old thread) to be the place for wish list items in the future, but am not shure about that right now. A second thread just for the wish list seems a little misplaced IMO. What do you think? Regards, Frederik |
| Fennec:
--- Quote from: frozenfrogz on April 12, 2017, 08:12:09 pm ---Please provide your long system info, thanks :) --- End quote --- I post nothing. Since my last RESET my scope is complete ded. It boots up with this screen. |
| ankerwolf:
Hello, I made update now on my DS1054Z (with Options now DS1104Z): SW: 00.04.04.03.02 = 00.04.04.SP3 Board: 0.1.1 Boot: 0.0.1.3 FW: 0.2.3.11 CPLD: 1.1 Warm up >30' Update ok > Power off > Power on 1. SelfCal (I seem to recall there were two more SoftButtons: [... LF ...] and [... Output ...] ) >>> FAILED !!! Same screen as Fennec !!! > Power off > Power on 2. SelfCal (now only two SoftButtons) > ok. LG Wolf |
| frozenfrogz:
--- Quote from: Fennec on April 12, 2017, 08:41:48 pm ---I post nothing. Since my last RESET my scope is complete ded. It boots up with this screen. --- End quote --- Damn. Did you try deep cycle / alternative reset? PDF from Rigol on alternate reset Also there is a memory clearing procedure: PDF from Rigol on sanitizing memory Good luck! |
| Fennec:
Telnet still work. I check it tomorrow. All knobs around the screen are ded. So Start or Exit wouldn't work. The screenshot takes a li'll less than 30 MIN. ! Never never again I buy those cheap crap from Rigol ! hf "Pluses" Thx for the PDF btw. |
| Navigation |
| Message Index |
| Next page |
| Previous page |