Products > Test Equipment

Rigol DS1000Z series buglist continued (latest: 00.04.04.04.03, 2019-05-30)

<< < (70/74) > >>

DC1MC:

--- Quote from: Adrian_Arg. on October 30, 2021, 02:54:55 pm ---I read the list from version 00.04.05.02.00 onwards, and it scares me to update, it corrects a lot of errors, but what it can create scares me more  >:D, for something they still did not correct the 24bit deep, they do not want to think about what would happen !! :-//

--- End quote ---

I have loaded and tested the firmware, from calibration, to licenses (all active) to signal shapes compared with previously saved values, to measurement. I can tell that there are no visible regressions.

 Cheers,
 DC1MC

Adrian_Arg.:

--- Quote from: DC1MC on October 30, 2021, 03:10:58 pm ---
--- Quote from: Adrian_Arg. on October 30, 2021, 02:54:55 pm ---I read the list from version 00.04.05.02.00 onwards, and it scares me to update, it corrects a lot of errors, but what it can create scares me more  >:D, for something they still did not correct the 24bit deep, they do not want to think about what would happen !! :-//

--- End quote ---

I have loaded and tested the firmware, from calibration, to licenses (all active) to signal shapes compared with previously saved values, to measurement. I can tell that there are no visible regressions.

 Cheers,
 DC1MC

Friend, I installed the firmware, it was installed correctly, the yellow trace and the others were left above the marker, and it does not allow to calibrate, it gives an error at 5 minutes, how degraded?

--- End quote ---

DC1MC:

--- Quote from: Adrian_Arg. on October 30, 2021, 03:49:56 pm ---...
Friend, I installed the firmware, it was installed correctly, the yellow trace and the others were left above the marker, and it does not allow to calibrate, it gives an error at 5 minutes, how degraded?

--- End quote ---


I've installed it on a MSO1074Z (I can provide pictures if needed), I was having exactly zero issues: the procedure was:
Installing -> Power Cycling -> Factory Reset -> Calibration -> Other tests regarding the the behavior.

Everything went A-OK

EDIT: The firmware was taken from here: https://www.rigolna.com/firmware/ and I've used the DS1000Z version, suitable for my scope.

DC1MC

Adrian_Arg.:
On the sixth try I calibrate, I really don't know what happened to the baby :(, gracias DC1MC :-+

DC1MC:

--- Quote from: Adrian_Arg. on October 30, 2021, 04:21:05 pm ---On the sixth try I calibrate, I really don't know what happened to the baby :(, gracias DC1MC :-+

--- End quote ---
No hay de qué.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod