Products > Test Equipment
Rigol DS1000Z series buglist continued (latest: 00.04.04.04.03, 2019-05-30)
rbino:
Reporting in, since yesterday I've upgraded to 00.04.04.03.02 (starting from the version ending with SP1, I can't remember the precise version).
Software version: 00.04.04.03.02
Board version: 0.1.1
Boot version: 0.0.1.2
Firmware version: 0.2.3.11
CPLD version: 1.1
I can't reproduce the Zoom lock-up (issue number 5), so it's a PASS for me.
After the software upgrade, the additional buttons on the auto-calibration showed up, and the auto-calibration failed.
When I've rebooted, the buttons were gone, but the calibration failed again.
Both the times the only symptom was the calibration failing, the scope didn't lock-up and I could continue to use it.
I will now try another self-calibration, if it fails again I will try cleaning the memory as BravoV did.
rbino:
Ok, I've just finished the third self-calibration since the software upgrade and this time it didn't fail. :-+
frozenfrogz:
Thanks rbino for reporting in.
So basically the freeze bug can not be pinned down to any given device stats – strange.
Nice to hear that you could finally initialize/calibrate your scope.
Did it just work on the third try, or did you do some memory clean or alternative reset?
szpila:
Yesterday, I've updated my scope to latest firmware. After that calibration went smooth without any errors. I've noticed two more buttons on calibration screen.
Wys?ane z mojego 2014811 przy u?yciu Tapatalka
Sredni:
--- Quote from: BravoV on April 19, 2017, 04:01:17 pm ---Big jump, just upgraded DS1104Z-S (with FG), from v04.00.00.00 straight to v04.04.03.02,
--- End quote ---
How come your Board Version has been updated, too?
From 0.1.1 to 4.1.1.
I thought that was only possible in hardware.
EDIT: I'll chip in with my USB weirdness.
Every now and then the USB stick I save screenshots on (it's mostly a Sandisk Cruzer 4GB) gets corrupted. I experienced blue screens of death the moment I try to open the stick's folder ("Windows has been shut down to prevent damage to your computer. Yaddayadda... PAGE_FAULT_IN_NONPAGED_AREA yaddayadda... Fastfat.sys").
This only happens with the stick I use with the scope. I changed stick, it still happened. I emptied and reformatted the stick, it still happened.
PC has the latest bios and the latest usb drivers according to the manufacturer. It also happened on another computer.
One other USB weirdness (probably associated to this) it that sometimes I found a corrupted filesystem on the stick with multiple files with the very same filename. For example two files with the name "DS1Z_QuickPrint12".
Yeah, you read it right: two files with the same filename.
I believe weird stuff began to happen when I started saving screenshots on a stick from where previous screenshots had been removed. It may have something to do with the way the DS1054Z names files. It seems to start from the lowest number available, but if after that there is a higher numbered filename still present, it messes things up.
I am now on version v00.04.04.01.01 (2016/09/14) - board version 0.1.1 - but it happened on v00.04.03.01.05 2015/06/16 and v00.04.02.04.07 2014/12/31, too.
I am now stalling the upgrade to the last one because I'd hate to make it worse.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version