Products > Test Equipment
Rigol DS1000Z series buglist continued (latest: 00.04.04.04.03, 2019-05-30)
maxiq4:
Im updated, ds1054Z, self cal is ok
but why not show boot version etc?
my system info menu short. have any body know why?
metrologist:
--- Quote from: maxiq4 on April 26, 2017, 05:33:12 am ---Im updated, ds1054Z, self cal is ok
but why not show boot version etc?
my system info menu short. have any body know why?
--- End quote ---
--- Quote from: ProBang2 on April 21, 2017, 02:01:25 pm ---How to get in the "expanded mode"?
Fast pressing the hard buttons [Menu] [Menu] [Force] [Menu]
Then pressing the hard button [Utility]
After that:
Press the soft buttons <System> and <System Info> gives the expanded system info.
Or, press the soft button <Self-Cal> and the scope shows the usual two soft buttons "Start" and "Exit"
and additional two soft buttons: "LFCal" and "Output".
With a DS1054Z both functions are failing. :-//
Perhaps the first is associated to an inbuild logic analyzer, the second to the function generator of a 1054S?
--- End quote ---
maxiq4:
thank you :)
video:
Hello,
sorry for my english, it's not my mother langage
It's my first message here, but i read sometimes this topic as i'm an new DS1054Z owner.
Just a remarq:
The second bouton "Output" could be named "WFCal" for "Write File Calibration" and of course the first hidden button (what is named "LFCal") seem to be "Load File Calibration".
But i didn't try to "Load" (if it's really a loading function..)..to much afraid..
Does anybody say if i'm wrong or right ?
Roeland_R:
Hello,
Just upgraded my scope. First sanitized and warmed up. (Had still the last version from 2015 before pulses function was introduced) All went fine. Only first calibration failed after about 30%. Second calibration (no reboot, just started again) did well. Only difference with all other scopes mentioned in this thread is the CPLD version 2.3
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version