Products > Test Equipment

Ridiculously small Rigol DS1000z series font size

<< < (4/35) > >>

Mark_O:

--- Quote from: nuno on July 27, 2014, 12:31:43 pm ---Funny how you can adjust the font size in a $60 "crapy" phone but not on semi-professional $900 equipment :palm: .

--- End quote ---

Funny how devices with different purposes have different functionality.

You also can't adjust font size on Rigol's top-of-the-line, most expensive scopes, which are priced over $9,000.  So it's funny you'd think it should be possible on their most inexpensive units at 1/10 the price.

nuno:
I hope (bet?) text is wide and clear on the 9K$ equipment. I see it as an ergonomics issue.

Orange:

--- Quote from: nuno on July 27, 2014, 05:13:20 pm ---I hope (bet?) text is wide and clear on the 9K$ equipment. I see it as an ergonomics issue.

--- End quote ---
You need glasses, and stop moaning about it. Nobody has problem with it.

pascal_sweden:
Maybe the support ticket will be implemented?
If the support engineer is on your side, it might make it in the next firmware update.
Just have patience I would say.

Maxlor:
Heh it's funny that your irked by the tiny font. Just the other week I was thinking that Rigol really need to clean up their UI design as far as fonts are concerned. There are way too many different ones used on the 1000Z. And the measurement font is particularly terrible. It's too small, and even worse, it's a bitmapped serif font on a low res display, which makes it extra hard to read. Rigol: use a sans serif font, pick two sizes (none smaller than 3mm), and stick with those everywhere!

I also long for the firmware upgrade that cleans this up, but I fear we won't ever be so lucky.

And yes I agree, the 1000E series is better in this regard. Strangely enough though, that ugly serif font shows up there too, in the language selection option. It's like a (rotten) easter egg.

Navigation

[0] Message Index

[#] Next page

[*] Previous page