Products > Test Equipment
Rigol DS1000z/2000/4000/6000 Waveform Capture Utility
<< < (5/10) > >>
JDubU:

--- Quote from: AlessandroAU on December 23, 2014, 05:39:06 am ---I am still working on support for other scopes, currently it is quite hard as I only have access to a 1074z. So far my program only detects which series scope is selected. It does not yet load configuration changes for the higher model scopes. If you have a ds2000 I could send you a WIP to try if you would like.

--- End quote ---

I do have a DS2000 and would be happy to test a WIP.
AlessandroAU:

--- Quote from: JDubU on December 23, 2014, 06:29:10 am ---
--- Quote from: AlessandroAU on December 23, 2014, 05:39:06 am ---I am still working on support for other scopes, currently it is quite hard as I only have access to a 1074z. So far my program only detects which series scope is selected. It does not yet load configuration changes for the higher model scopes. If you have a ds2000 I could send you a WIP to try if you would like.

--- End quote ---

I do have a DS2000 and would be happy to test a WIP.

--- End quote ---


Let me know if this version works for you:

V2.2.3

http://s000.tinyupload.com/?file_id=90659414641703074947

pa3bca, Please also try that version and let me know if it fixes any of the issues you were having. :)

aroby:
I tried the prior version (2.2.1) with my DS2072A / DS2302A.  I had to manually enter TCPIP::10.10.10.45::INSTR in the drop down menu, but it was able to connect.  With 2.2.3, I do the same and just get Error in the Model Detected field.

Anthony
AlessandroAU:

--- Quote from: aroby on December 24, 2014, 04:39:20 am ---I tried the prior version (2.2.1) with my DS2072A / DS2302A.  I had to manually enter TCPIP::10.10.10.45::INSTR in the drop down menu, but it was able to connect.  With 2.2.3, I do the same and just get Error in the Model Detected field.

Anthony

--- End quote ---

I haven't implemented TCP/IP, can you try with usb?

Edit, Hang on, were you able to connect over TCP/IP in version 2.2.1 and download a waveform?
aroby:

--- Quote ---I haven't implemented TCP/IP, can you try with usb?

Edit, Hang on, were you able to connect over TCP/IP in version 2.2.1 and download a waveform?

--- End quote ---

Yes.  Just tried it again.  I can do a screen capture.  In the Realtime Capture tab, I can select channels, I can see a waveform (but it says "Input is invalid!" on the scope), if I change the scales on the scope, the graphs change.  On Long Memory Capture, changing the # of points gets reflected on the scope (albeit with the issues previously described).  When I hit Capture, the scope Stops, I get Input is invalid, and nothing gets displayed.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod