Products > Test Equipment
Rigol DS1000z/2000/4000/6000 Waveform Capture Utility
bozidarms:
Hi to all,
i have try (DS4012) this great software, but have some problems-
1.instability
2.on FFt screen levels are 10dB too low
Is any further plans for improvements or work on it - think that software has the potential to be a great tool
Tnx, regards,
Bozidar
AlessandroAU:
--- Quote from: cubitus on July 03, 2015, 05:27:27 am ---Hello,
This does not change anything ...
--- End quote ---
You have a very strange error, it cannot find the files that should have been installed with the labview RTE. Do you install the RTE to a strange location?
zxc_pavel:
Good day. Links in your post are broken now. Could you update it, please?
Thanks
antoniobeta:
--- Quote from: AlessandroAU on December 18, 2014, 11:48:22 am ---I posted this Utility in the Rigol DS1000/DS2000 jitter thread and since it seemed to attract some interest I figured I'd start a new topic.
Its written in Labview so you will need the Labview RTE http://www.ni.com/download/labview-run-time-engine-2014/4887/en/
Looking at the VISA commands this should also be compatible be somewhat compatible with the entire DS series from Rigol. I would expect the Real-time Capture to have no issues but there may be problems with the Long Memory Capture on other models scopes (I am using a DS1074z). If you have a DS2000/4000/6000 please test this and let me know.
Current Version V2.2.3
Rigol V2.2.3
http://s000.tinyupload.com/index.php?file_id=90659414641703074947
Rigol V2.2.1:
http://s000.tinyupload.com/index.php?file_id=06194785972356290806
Rigol V2.2
Download Link: http://s000.tinyupload.com/index.php?file_id=16159701921368811937
Source: http://s000.tinyupload.com/index.php?file_id=05957966868497599811
Known Bugs:
Long Memory Capture only supports one channel at a time and trigger channel must be the same as capture channel. For now it is a good idea to disable other channels when using this.
Memory Depth setting is only updated when a new menu selection is made.
In real-time capture mode changing channel options sometimes results in a communication error, stop cont. sampling before changing memory settings to avoid this.
Waveform statistics cannot compute more than 3Mpoints of data (labview limitation) currently statistics are calculated from the first 50Kpoints to improve speed.
Rigol DS1074z Bugs:
Scope complains of 'Invalid Input' but processes commands anyway. (Perhaps I do not known the exact sequence it expects) commands work regardless.
When using :WAV:DATA? to request samples there is an upper limit of exactly 1179644 data points that can be downloaded at any one time requesting more points using :WAV:START and :WAV:STOP will result in a no data being returned at all.
Note this is when downloading the data as bytes ie :WAV:FORM BYTE, if using :WAV:FORM ASC (ascii) the limit is reduced to around 60Kpoints.
However it is possible to download the entire waveform memory in blocks and this is the technique I have used to download more than 1.1Mpoints.
--- End quote ---
Hi! All links seems to be dead. Could you please reupload?
Navigation
[0] Message Index
[*] Previous page
Go to full version