Products > Test Equipment
Rigol DS1054Z rotary encoder mod *works!*
(1/28) > >>
Penguin36:
As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

Update: its working, see Reply #4
tautech:

--- Quote from: Penguin36 on August 19, 2015, 02:40:10 pm ---As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

--- End quote ---
Detented
Penguin36:

--- Quote from: tautech on August 19, 2015, 02:53:26 pm ---
--- Quote from: Penguin36 on August 19, 2015, 02:40:10 pm ---As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

--- End quote ---
Detented

--- End quote ---
Thanks :-)
andersm:
Depends on whether Rigol are counting all four edges of the encoder waveform or not.
Penguin36:
So, I gave it a try, changed the rotary encoder with a detented type. This is working without problems :-)
Very nice selecting menu options, selecting chars, and NO jumping when pressing the button!

I will describe the mod in short time, if you like ....
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod