Products > Test Equipment

Rigol DS1054Z rotary encoder mod *works!*

(1/28) > >>

Penguin36:
As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

Update: its working, see Reply #4

tautech:

--- Quote from: Penguin36 on August 19, 2015, 02:40:10 pm ---As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

--- End quote ---
Detented

Penguin36:

--- Quote from: tautech on August 19, 2015, 02:53:26 pm ---
--- Quote from: Penguin36 on August 19, 2015, 02:40:10 pm ---As we know, selecting values or chars with the rotary encoder knob on the 1054Z and similar is a pain.

Can't we change the rotary encoder with one that has these stepping grid? Sorry, I dont't know the correct words for that, I'm german. But I'm sure you know what I mean :-)

--- End quote ---
Detented

--- End quote ---
Thanks :-)

andersm:
Depends on whether Rigol are counting all four edges of the encoder waveform or not.

Penguin36:
So, I gave it a try, changed the rotary encoder with a detented type. This is working without problems :-)
Very nice selecting menu options, selecting chars, and NO jumping when pressing the button!

I will describe the mod in short time, if you like ....

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod