EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: tom66 on June 10, 2015, 06:18:43 pm
-
I've noticed recently that if I wiggle the BNC connector, CH1 signal varies (independent of the probe.) At one time, signal was 1/10th what it was. Works most of the time, but caught me out for a while doing some tests. I use CH1 most often on my scope...
Must be an issue with solder or components around the BNC. The scope is still under warranty, but it'll be a hassle to send it back.
Wondering if anyone else has encountered this issue?