Products > Test Equipment
RIGOL DS1102Z-E
Fungus:
--- Quote from: PatrickB on January 26, 2023, 08:00:42 am ---The loss of brightness and other problems reported in this forum by users are not software problems as Rigol and others have told me.
--- End quote ---
Yes they are.
trmntr:
Just when new firmware comes out, they have a description of what has been changed or fixed. But there is no information anywhere about what has been improved or fixed in the latest (possibly the latest) hardware version.
On the one hand, if a manufacturer makes changes to its product and this is not a correction of an old error in the board layout, but an upgrade, then this is understandable, but when three years have passed since the launch of this sight on the market and when you buy a device, you get the first version of hardware with a possible flaw in the circuit, it becomes a little unpleasant)
Fungus:
Have you observed any flaws that people with newer PCBs don't have?
trmntr:
I have not seen such examples yet. Indeed, it would be interesting to hear here the owner of a DS1102Z-E with motherboard version 0.0.13. Are there any problems with this version of the board as well?
Ogurezzz:
Hello everyone.
Just get my DS1102Z-E. It doesn't show signal lines. Both channels are ON, but it looks like it doesn't feel any trigger signal.
What it could be?
FW: 00.06.03.SP2
Board: 0.0.1
I tried to do Self-Cal, it writes "Disconnect everything from all inputs!" And progress bar doesn't move.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version