Products > Test Equipment
RIGOL DS1102Z-E
Fungus:
--- Quote from: Ogurezzz on February 05, 2023, 06:58:25 pm ---Hello everyone.
Just get my DS1102Z-E. It doesn't show signal lines. Both channels are ON, but it looks like it doesn't feel any trigger signal.
--- End quote ---
Maybe it's set to external trigger.
--- Quote from: Ogurezzz on February 05, 2023, 06:58:25 pm ---I tried to do Self-Cal, it writes "Disconnect everything from all inputs!" And progress bar doesn't move.
--- End quote ---
But that sounds bad.
trmntr:
Could it be a software glitch? Do a factory reset.
PatrickB:
trmntr is right, a factory reset might solve your problem.
On the Rigol, which I had, it was impossible to reinstall the latest version of the software after trying older versions.
At each attempt to reinstall the latest software version, the scope displayed "Update was failure". >:(
To perform a hard reset, I had received from Rigol the following procedure and it worked, the latest software version could be reinstalled:
"Put latest firmware on to the root directory of a jump drive formatted to FAT32. The newest firmware can be downloaded from https://www.rigolna.com/firmware/.
While the device is off, insert the drive into the USB port in the front. Start repeatedly mashing the "Help" button and power up the unit while continuing to press the button repeatedly. This should cause the device to try to boot from the external drive with the new firmware. If the firmware is loaded successfully, the instrument should not boot into the red screen error, but it will remain unresponsive while the firmware is installed - this can take up to a few minutes."
At the end of this long procedure, the messages displayed are in Chinese languages but the button to change languages automatically appears on the right of the screen. It's good.
trmntr:
Hi!
I found one bug in the operation of the oscilloscope and I would like you to check it for yourself in order to understand it only for me or for all Rigol of this series ...
Turn on the device, turn on one or two channels. On the left side of the menu, select measurements for the channel, for example, Vpp. In the Measure menu where Font size choose Large or Extra Large. Go back a little now to Statistic and slowly toggle this between ON and OFF. In this case, the selected Vpp parameter will switch to the extended window and back. At some point (no more than a minute), the device freezes, stops responding to the buttons. Beam settings can still be changed with encoders, but no correct parameters are displayed on the screen.
https://www.bilibili.com/video/BV1KM4y167vV
https://youtu.be/G7CreVuakn0
Piton:
Hello. It doesn't freeze in my auto mode. In the "Normal" mode, it does not freeze immediately, but in single mode - immediately to a black screen.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version