Products > Test Equipment

RIGOL DS1102Z-E

<< < (36/36)

trmntr:
Take a short video.  I have the same behavior in all three modes.

trmntr:

--- Quote from: Fungus on September 02, 2022, 06:43:09 pm ---
--- Quote from: RogerG on September 02, 2022, 02:57:42 pm ---Hello,

I own a brand new DS1102Z-E since a few weeks and tried to replace this horrible, non-indexed multipurpose encoder. I found the Bourns PEC11R-4215F-S0024 (24 positions) but with this encoder the Scope always triggers the menu twice, so it jumps over one menu item :palm:.

Any other suggestions for the correct encoder?

--- End quote ---

Presumably you want the one with less pulses:  Bourns PEC11R-4215F-S0012

https://www.bourns.com/docs/product-datasheets/pec11r.pdf

--- End quote ---
Hello.  I tried replacing the native encoder with another one with 12 clicks and 12 pulses.  If you do not rotate quickly, the menu bar jumps two positions.  Do I understand correctly that for correct operation me will need an encoder with a number of pulses that will be half as many clicks?

trmntr:
As a result, I installed this encoder from the link below.  Fits very well.  Both in height and in work.

https://aliexpress.ru/item/4000914884857.html

mike_mike:
Hello ! The DSO model that I use is DS1102Z-E. I notified that if I set the trigger to auto and the memory depth is set at 600k or below, then if triggering to the LM555 output on pin 3 (the LM555 is from the attached schematic) the waveform doesn't stabilize. But if changing the trigger to normal or set the memory depth above 600k then the waveform is stabilized. Is this normal ?
If I trigger on the calibration signal with the initial DSO settings (600k memory depth and auto trigger) then the waveform looks good.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod