Products > Test Equipment
RIGOL DS1102Z-E
svetlov:
BTW2: I find the Multipurpose Knob very sensitive... Often changing the selection during enter/press
you can replace the encoder yourself! this video shows in great detail how to do it
in order to understand the narrator - click the subtitle icon - then go to the settings menu - click there subtitles - translation - and select your native language!
calli:
Great, I planned that some time but was too lazy until now!
C!
Piton:
I want to ask everyone if this is the case: when the second channel is turned on, the first, together with the second, shifts to the minimum vertical limits, but if you switch both channels to the ground, and then back, then everything falls into place. It is not yet clear why the relay always clicks when the second channel is turned on? There is no such thing with the first one.
enectromess:
hi, with new firmware v00.06.03.02.02 2021-10-20 my ds1102z-e sometimes don't boot right. (I think the cause is new firmware but I'm not sure) I have to measure voltages at the connector. Work in progress.
enectromess:
Voltages seem ok. PSU is based on LD7575 (current-mode PWM controller) + 2SK3569 (power mosfet) also PCB seems quite neat. well welded and well made :-+
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version