Products > Test Equipment

rigol ds2202 does not auto on i2c

(1/3) > >>

Aido4ever:
Hi everyone.
I got my new rigol ds2202 and i got 2 problems.

1. the scope does not auto set when on i2c i only use manual setting.
2. i got no decoding on i2c.

another thing: i got no calibration certificate with the scope, and i got it with a dust on the screen. can i be it's not new?

thank you all.

marmad:

--- Quote from: Aido4ever on May 01, 2013, 11:25:50 pm ---1. the scope does not auto set when on i2c i only use manual setting.
--- End quote ---

Auto setting functions are normally extremely simple; I've never tried it but I doubt they work on any complex triggers.


--- Quote ---2. i got no decoding on i2c.
--- End quote ---

Well, I don't know what to tell you about that. I've used the I2C decoding on the DS2000 and it seemed to work fine; you can see me doing it here in my video.

Galaxyrise:
Does it show the trial licenses when you power it up? 

EV:

--- Quote from: Aido4ever on May 01, 2013, 11:25:50 pm ---Hi everyone.
2. i got no decoding on i2c.

--- End quote ---

It works fine. Have you tried different sweep times?

Aido4ever:

--- Quote from: Galaxyrise on May 02, 2013, 05:14:50 am ---Does it show the trial licenses when you power it up?

--- End quote ---

yes. and it shows i have this option on trial...

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version