Products > Test Equipment
Rigol DSA 815-TG upgrade/ hack ?
(1/4) > >>
VE7XDT:
Hi to all

I am new to this forum but I read a lot of the postings.
I just purchased an used Rigol DSA 815-TG that has 23 hours left of the free trial.
I am not sure what is the best way to upgrade to the new software or do the clock mod?
It is confusing from all different answer and compatibility issues.
I tried the Rigol keygen and entered the codes but got the "invalid codes " message
I tried with space ( no "-" available) then all together with no spaces , same message
I hope some one can help.

Here is what I have:

Main board  04
RF FPGA    05
Dig. FPGA  04
Firmware   01.08
Boot          01.03

What would be the best approach?
I also included few pics from the DSA menu

Thanks
Dino
Helix70:
Did you try this?
VE7XDT:
Thanks for the prompt replay.

I saw the video, very simple mod to do.
I am wondering about software upgrade and then hack the codes if that is a better alternative?
In case for the mod above I have to reverse the mod in order to upgrade but then I lost the free trial time according to some..
I noticed my screen shots are not the same as others...?!

Dino
Helix70:
I have read that it is not possible if you have 1.04 of the bootloader (https://www.eevblog.com/forum/chat/hack-of-rigol-dsa815-tg/msg795794/#msg795794) but you have 1.03, so perhaps you should be able to. I maybe wouldn't upgrade firmware though if you do it, you might lose it. What keygen did you use?
VE7XDT:
This is the one I used:

http://gotroot.ca/rigol/riglol/

I tried several ways of entering the codes but no luck.

I also wondered if there is something valuable in upgrading to a newer rev software?
I have 100 Hz BW not the 10 Hz .. not a big deal for me..

On the clock mod : some people lift pin & and short to pin 8, others just short them together.
Which is the correct way to do the mod?!

Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod