Products > Test Equipment
Rigol DSA 815-TG upgrade/ hack ?
VE7XDT:
Hi to all
I am new to this forum but I read a lot of the postings.
I just purchased an used Rigol DSA 815-TG that has 23 hours left of the free trial.
I am not sure what is the best way to upgrade to the new software or do the clock mod?
It is confusing from all different answer and compatibility issues.
I tried the Rigol keygen and entered the codes but got the "invalid codes " message
I tried with space ( no "-" available) then all together with no spaces , same message
I hope some one can help.
Here is what I have:
Main board 04
RF FPGA 05
Dig. FPGA 04
Firmware 01.08
Boot 01.03
What would be the best approach?
I also included few pics from the DSA menu
Thanks
Dino
Helix70:
Did you try this?
VE7XDT:
Thanks for the prompt replay.
I saw the video, very simple mod to do.
I am wondering about software upgrade and then hack the codes if that is a better alternative?
In case for the mod above I have to reverse the mod in order to upgrade but then I lost the free trial time according to some..
I noticed my screen shots are not the same as others...?!
Dino
Helix70:
I have read that it is not possible if you have 1.04 of the bootloader (https://www.eevblog.com/forum/chat/hack-of-rigol-dsa815-tg/msg795794/#msg795794) but you have 1.03, so perhaps you should be able to. I maybe wouldn't upgrade firmware though if you do it, you might lose it. What keygen did you use?
VE7XDT:
This is the one I used:
http://gotroot.ca/rigol/riglol/
I tried several ways of entering the codes but no luck.
I also wondered if there is something valuable in upgrading to a newer rev software?
I have 100 Hz BW not the 10 Hz .. not a big deal for me..
On the clock mod : some people lift pin & and short to pin 8, others just short them together.
Which is the correct way to do the mod?!
Navigation
[0] Message Index
[#] Next page
Go to full version