Products > Test Equipment
Rigol HDO1000 VESA Mount
<< < (3/3)
JJ_023:

--- Quote from: Martin72 on November 26, 2023, 03:18:06 pm ---3D cad software you can get free and for the printing you can use this here:

https://jlc3dp.com/?source=jlc3dp-footer

No problems at all.

--- End quote ---

I do a lot of this stuff for a living I can tell you it's not as simple.  The CAD part I would agree with you.  There are plenty of free programs out there That you can use to achieve this.

In reality when you are doing something that needs fitment or hole location.  Unless you are really good at what you do you are not going to get it right the 1st time (and people that are good at this usually have access to the printer). 

Which means if you don't have a printer on hand and you are outsourcing you are going to be not only wasting a lot of time due to the turnaround time of the process and the third-party but the costs associated with the simple project like this can get out of hand compared to the application it is intended for. 
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod