| Products > Test Equipment |
| Rigol MSO 5000 hardware/software revisions |
| << < (56/84) > >> |
| skander36:
--- Quote from: sb42 on March 16, 2020, 09:58:52 pm --- --- Quote from: skander36 on March 16, 2020, 08:12:45 pm ---Try this : Set Default -> Activate G1(default settings) connect a cable from G1out to CH1 input->Press AUTO Let us know what's happened. Maybe some scopes are defective . --- End quote --- That displays the sine wave on CH1, the other three channels stay off. --- End quote --- My scope is doing as can be seen here : https://youtu.be/2Uvl-dC13Pc If it is defective, why is not doing this on Fw. 04.08 and below ? Calibration does not change anything . |
| pmaggi:
Is it possible to back to 00.01.04.08? |
| skander36:
--- Quote from: pmaggi on March 22, 2020, 07:16:51 pm ---Is it possible to back to 00.01.04.08? --- End quote --- Yes . With "SINGLE" key at boot time . |
| sb42:
--- Quote from: skander36 on March 22, 2020, 06:52:51 pm --- --- Quote from: sb42 on March 16, 2020, 09:58:52 pm --- --- Quote from: skander36 on March 16, 2020, 08:12:45 pm ---Try this : Set Default -> Activate G1(default settings) connect a cable from G1out to CH1 input->Press AUTO Let us know what's happened. Maybe some scopes are defective . --- End quote --- That displays the sine wave on CH1, the other three channels stay off. --- End quote --- My scope is doing as can be seen here : https://youtu.be/2Uvl-dC13Pc If it is defective, why is not doing this on Fw. 04.08 and below ? Calibration does not change anything . --- End quote --- It certainy seems less "defective" than mine going by the noise levels :) Have you tried firmware 00.01.02.00.03? |
| skander36:
Yes , I said before. Both 02 & 03 have the same behavior. |
| Navigation |
| Message Index |
| Next page |
| Previous page |