Products > Test Equipment

Rigol MSO 5000 hardware/software revisions

<< < (56/84) > >>

skander36:

--- Quote from: sb42 on March 16, 2020, 09:58:52 pm ---
--- Quote from: skander36 on March 16, 2020, 08:12:45 pm ---Try this :
Set Default -> Activate G1(default settings) connect a cable from G1out to CH1 input->Press AUTO

Let us know what's happened.
Maybe some scopes are defective .

--- End quote ---

That displays the sine wave on CH1, the other three channels stay off.

--- End quote ---
My scope is doing as can be seen here : https://youtu.be/2Uvl-dC13Pc
If it is defective, why is not doing this on Fw. 04.08 and below ?
Calibration does not change anything .




pmaggi:
Is it possible to back to 00.01.04.08?

skander36:

--- Quote from: pmaggi on March 22, 2020, 07:16:51 pm ---Is it possible to back to 00.01.04.08?

--- End quote ---
Yes . With "SINGLE" key at boot time .

sb42:

--- Quote from: skander36 on March 22, 2020, 06:52:51 pm ---
--- Quote from: sb42 on March 16, 2020, 09:58:52 pm ---
--- Quote from: skander36 on March 16, 2020, 08:12:45 pm ---Try this :
Set Default -> Activate G1(default settings) connect a cable from G1out to CH1 input->Press AUTO

Let us know what's happened.
Maybe some scopes are defective .

--- End quote ---

That displays the sine wave on CH1, the other three channels stay off.

--- End quote ---
My scope is doing as can be seen here : https://youtu.be/2Uvl-dC13Pc
If it is defective, why is not doing this on Fw. 04.08 and below ?
Calibration does not change anything .

--- End quote ---

It certainy seems less "defective" than mine going by the noise levels :)

Have you tried firmware 00.01.02.00.03?

skander36:
Yes , I said before.
Both 02 & 03 have the same behavior.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod