Products > Test Equipment
Rigol MSO 5000 hardware/software revisions
Martin72:
--- Quote ---Some other brands requires you to upgrade all your probes when you upgrade the bandwidth
--- End quote ---
Oh yes…. :P
Gandalf_Sr:
I'm getting nothing from my HDMI connector although I'm trying an old monitor that only has DVI which I'm trying with a DVI-HDMI adapter.
Earlier in this thread skanders (I think) says...
v00.01.02.00.02 2020/02/25
- Optimized the connection HDMI start problem optimized the connection HDMI start problem
Questions:
1. Do I need to update to vn00.01.02.00.02 or higher to make it work?
2. Is there somewhere in the menus to turn on the HDMI? I can't find anything.
3. When the HDMI monitor is on, does the main screen stop working?
4. If I change the HDMI resolution for the external monitor does the main screen change too?
Thanks in advance
skander36:
HDMI work in any versions .
Just activate (every time ...:) ) through Utility-IO-HDMI ...
Gandalf_Sr:
--- Quote from: skander36 on April 13, 2020, 02:25:04 pm ---HDMI work in any versions .
Just activate (every time ...:) ) through Utility-IO-HDMI ...
--- End quote ---
Thanks, so it was under the IO menu, not the display menu; TILT |O
I plugged in 2 different monitors using the DVI-HDMI adapter, got nothing from either of them. My firmware is 01.01.04.08, any ideas?
skander36:
DVI must work is just a physical remapping of pins , signals are the same on both ends (HDMI to DVI) ...
Check that you have selected the right input on the monitor (VGA/DVI) ... I don't see other reason ...
P.S. Currently I am using the same fw.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version