Products > Test Equipment

Rigol MSO5000 Power Supply

(1/8) > >>

Protegimus:
Hi, has anyone already put together a BoM for upgrading components in the MSO5000 PSU?

Alternatively, any good quality images of the PSU board would be helpful. Appreciate they are gunked up.
I've been through Dave's teardown pic's, unfortunately there's not much visible.

Intent is to replace the CrapXon's with some high quality alternatives with the objective of improving noise filtering.

Others have already completed this work on different models and noted improvements.

beatman:
I have replaced all caps with Panasonic fc.is a mater of time the cap xones goes leaky.and I am sure the psu is more quiet with better caps

Protegimus:
Nice work beatman.
Do you have a record of what was needed that you are able to share?

Any disassembly tips?

beatman:
Only remove the back cover and Wright the value from all capacitors to paper. mf numbers must keep the same.voltage can be little higher. when you have the new caps open again the scop unscrew the psu and careffuly to not damage the traces do the job.i hoppe you have the skills.when I see crapxones on device i replace as soon is possible

perseverance8:
I too would like to have BOM for the MSO5K PSU, if I remember correctly the MSO5K' s PSU's enclosure is soldered on.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod