The 7000 has high resolution mode it was incorporated in the FW upgrade
[Supported Model] All the MSO/DS7000 Series Digital Oscilloscopes
[Latest Revision Date] 2019/07/23
[Updated Contents]
--------------------
v00.01.01.09.02 2019/07/23
- Reduced the waveform noise floor
- Optimized the waveform jitter caused by noise floor
- Optimized the system response under the deep memory condition
- Optimized the system response during the timebase adjustment process
- Optimized the auto configuration condition for FFT waveform
- Optimized the display effect during image saving
- Modified the occasional problem of not displaying the measurement results
- Optimized the user experience in cursor range adjustment in Measure setting
- Modified relevant problems concerning SPI decoding
- Modified address setting problems in I2C trigger
- Added to save GPIB address setting during power-on storage
- Modified the trigger sensitivity configuration. See Datasheet for details
- Optimized the start-up time for the oscilloscope, shortening it to about 1 minute
- Added a command :MEASure:STATistic:ITEM? CNT,<item>[,<src>[,<src>]]
- Supported exporting the waveform memory data of several analog channels simultaneously
- Added high resolution mode - Supported mouse operation for cursor
- Bandwidth upgrade option supported gradual upgrade
- Added the 500 uV/div vertical scale