| Products > Test Equipment |
| Rigol Ultra Sigma has stopped working... |
| << < (3/6) > >> |
| s3rkan:
--- Quote from: dagg on August 06, 2016, 07:01:37 pm ---Hi Bicurico :) that's a good point...! But it makes no difference over here, all's working fine on ',' or '.' for the decimal separator. s3rkan: Darn! :( Then I'd suggest to just uninstall Ultra Sigma -maybe more thoroughly needed, ie folders/appdata/registry/etc- and reinstall that. Because it might be that you started off in the reverse order; NI-VISA maybe needs to be installed 1st. I think NI-VISA will be installed correctly. A working Ultra Sigma on W7 is attached. Right-clicking on the highlighted scope, and choosing Ultrascope will start Ultra Sigma then. --- End quote --- I have uninstalled the Ultra Sigma and all its components with revo uninstaller. Installed the NI-VISA 16 first and installed the sigma then. Unfortunately, no success :( |
| dagg:
And version 00.01.06.00? :-// |
| dagg:
--- Quote from: Bicurico on August 06, 2016, 06:09:22 pm ---Hi. Just a wild suggestion, as I don't even own this device: Try changing the Regional Settings to a different country. Often the cause is just the "." vs "," for tge devimal separato. Regards --- End quote --- "Each Rigol Software requires DOT as decimal separator. [English/America Notation] So before starting with installation or usage of Rigol Software go to your Windows Control Panel and change the Region and Language settings to the right notation! Otherwise your software will not work properly." |
| s3rkan:
--- Quote from: dagg on August 06, 2016, 08:46:24 pm --- --- Quote from: Bicurico on August 06, 2016, 06:09:22 pm ---Hi. Just a wild suggestion, as I don't even own this device: Try changing the Regional Settings to a different country. Often the cause is just the "." vs "," for tge devimal separato. Regards --- End quote --- "Each Rigol Software requires DOT as decimal separator. [English/America Notation] So before starting with installation or usage of Rigol Software go to your Windows Control Panel and change the Region and Language settings to the right notation! Otherwise your software will not work properly." --- End quote --- :-+ :-+ :-+ OK, here is the point: change the regional settings to USA :o And voila 8) Thank you very much dagg and Bicurico! |
| dagg:
Sighhh, congratulations!! :clap: :popcorn: |
| Navigation |
| Message Index |
| Next page |
| Previous page |