Products > Test Equipment
Rigol Ultra Sigma has stopped working...
s3rkan:
Hi everyone. I have downloaded the both the 01.06.00 and 01.06.01 versions and tried to install with built in admin account as mentioned here. I have installed to 3 PCs with windows 8 x64, windows 7 x64, windows 7 x86 but in all of these the program crashed and said ".....has stopped working". Please could someone give me any advice?
dagg:
Did you also install the NI-VISA Virtual Instrument Software Architecture? It is mandatory for Ultra Sigma to function.
Jan.
s3rkan:
Does it have an additional setup file? I think it have been installed with the ultra Sigma setup that I have downloaded from rigol site.
dagg:
I can't really remember, but you should have an entry "National Instruments Software" in your software list. If it's not there, please download and install from your mentioned link, and work up to version 15.5 of that through the updates.
s3rkan:
--- Quote from: dagg on August 06, 2016, 01:20:12 pm ---I can't really remember, but you should have an entry "National Instruments Software" in your software list. If it's not there, please download and install from your mentioned link, and work up to version 15.5 of that through the updates.
--- End quote ---
I have reinstalled the windows 8 x64 and ultra sigma. A screenshot is attached. Also I downloaded the National Instruments Software and installed it. But still it says "... has stopped working"
Navigation
[0] Message Index
[#] Next page
Go to full version