EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: Gioreva on April 08, 2017, 07:00:06 am
-
My warranty sticker is non-removable.
I'm studying to make a copy for me, perhaps to sell it.
-
Dave has a video on this already.
https://www.youtube.com/watch?v=colVXihqdGo (https://www.youtube.com/watch?v=colVXihqdGo)
-
These are easily removable.
For me, the most convenient way of doing it is preheating it with my hot-air station set to lowest temperature, or use a hairdryer. Then I use a piece of PTFE, that I cut to a very flat wedge / knife.
Works every time.
-
This is different.
It breaks all
I warmed up as soon as I touched you have already removed the pieces
Only I have this type of adhesive?
-
Rigol have not changed their sticker, it is still the same one that everyone else here has had success removing using the above information, it just takes patience. A teflon or PTFE scraper is very handy here also.
-
If you look at my pictures, my adhesive is different.
I can not remove.
I've already ruined
-
No problem, I have your warranty stickers.
If someone needs some stickers, can contact me.