| Products > Test Equipment |
| LCR Impedance Viewer for Picoscope+Keysight+R&S Bode Plot Data (open source) |
| << < (10/30) > >> |
| Evodad:
Sorry if a confused you. The file was orginaly: log4net.log, this did not work to post so I changed it to log4net.log.txt This did not work either so I took log4net.log.txt and Zipped the file to log4net.log.txt.ZIP and changed the .ZIP with .txt to log4net.log.txt.txt. So to go back, change from .txt to .ZIP and then you should have your file after Unzipping. )) Kind regards, Per |
| _Wim_:
Ok, now I could open the log, but it seems like the log is not from the time the app crashed (the app was opened again afterwards, so more info was added to the log). I have added some more code to log better were I think the crash occurs. Can you please run the attached version, and copy the log to here directly after the app crash occurred? Did you try to run the app from the C-drive directly? |
| Evodad:
This should do it I hope, booth from 1008 and 1009. Just Zipped this time :) Running it from the C-drive didn't make a difference. )) Per |
| Hans Polak:
Wim, Thanks for the wonderful job you did, especially with the cursor and using FRA4PS as input works fine for me. I have a point to mention. In the image showing the impedance, the program also shows a phase. However this is the phase that belongs to the Gain. In the Image below I show the difference phase that belongs to the impedance. Hans |
| _Wim_:
--- Quote from: Evodad on April 22, 2019, 07:31:53 am ---This should do it I hope, booth from 1008 and 1009. Just Zipped this time :) Running it from the C-drive didn't make a difference. )) Per --- End quote --- Seems to be related to a 32-bit vs 64-bit conflict when calling the DLL from FRA4Picoscope. I suspect your running on x64, can you try if you can run the attached version, or experiment with running the exe in compatability mode. According to this (https://bitbucket.org/hexamer/fra4picoscope/wiki/Home), currently only 32-bit is supported (I am running still 32-bit, so this could be the reason). |
| Navigation |
| Message Index |
| Next page |
| Previous page |