Products > Test Equipment

Rohde & Schwarz CMU200

<< < (24/71) > >>

cmu2017:
Too bad that there is no switchable 12v. Have you maybe a photo or something else to see where I can find that 12v?

Qw3rtzuiop:
You can take a look at the service manual. There are the connector descriptions. The 12V should be present at almost any of the big connectors at the main pcb.

Edit:
Here is the spare parts list with the connector descriptions:
http://www3.rohde-schwarz.com/www/FileTranCS.nsf/4073a08b63359686c1256ae6002f8239/0b37697a081fa22ec1257834002005ed/$FILE/Shb-inst_Documents.pdf
Its not in the service manual.

cmu2017:
Thanks, I found it.

cmu2017:
Does anyone have the print design of the motherboard? I want to cut some small part of the corner. So I can place a new rivet nut for the leg. But I need to be sure there is no circuit on that place. (See image)

cmu2017:
I’m using the cmu200 now for a while and I have a few questions about it which I couldn’t find on the manual.

- Is it possible to set a ref -> pk  to a negative peak
- Can I change the power measure form dbm to watt
- Is it possible to make a print screen save it a usb stick

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod