Products > Test Equipment
Rohde & Schwarz CMU200
Bicurico:
Perhaps this may interest you guys: http://vma-satellite.blogspot.pt/2018/03/vma-simple-spectrum-analyser-for-crtu.html
Regards,
Vitor
richnormand:
Just downloaded.
Can't wait to try it.
Thanks for the work Vitor.
CJay:
It does and I've downloaded copy but have yet to find time to hook everything up.
Looks very impressive though
Bicurico:
Some info:
This is still the first version and there are some bugs, obviously. Also, I want to increase the functionality. Unfortunately I have had zero time for my hobbies in the past weeks.
In order to get the software working, the following is needed:
- CMU200 or CRTU with firmware v5.20 if serial connection is to be used - not tested with older firmware releases, but it seems that only v5.xx offers 115200 baud
- Keysight Connection Expert 2018: some users reported that it doesn't run with older versions. I don't know, because I only tried this version.
- Recommened: Agilent GPIB/USB interface (I ordered a "refurbished" one from China through eBay and it cost me around 80 Euro plus 60 Euro for customs).
- You need to setup remote connection on the CMU200/CRTU: test it with Keysight Connection Expert 2018. If it works here, it should work with my software.
- To run my software, you need a (free) activation code.
Regards,
Vitor
ps:
--- Quote from: cmu2017 on March 23, 2018, 07:39:04 am ---- Is it possible to set a ref -> pk to a negative peak
- Can I change the power measure form dbm to watt
--- End quote ---
Check the list of GPIB commands. There are a couple of funtions and settings that are not accesible with the front panel controls. If it isn't there, it is not possible.
--- Quote ---- Is it possible to make a print screen save it a usb stick
--- End quote ---
No. MS-DOS does not support any USB at all. There is a USB to PS/2 keyboard emulation in the BIOS, therefore an USB keyboard will work, but that is the only device type supported.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version